| HOW TO MAKE HHO: First Steps | | | | s pipe is going to be powered by a single coil-pack |
| The first items you'll want to obtain are an 18 inch | | | | (Coil packs are used to ignite spark plugs on later |
| long piece of PVC, about 6 inches in diameter as | | | | model cars). You'll connect all 8 coils to the eight 3 |
| well as 1/4 and 3/4 inch s/s pipe--each a bit less | | | | 4 inch s/s pipes. |
| than 18 inches in length. So you'll have 3 1/4 and | | | | HOW TO MAKE HHO: Final Steps |
| 8 3/4 s/s pipes. You'll also need to get something | | | | We're entering into the last stages of the "how to |
| for separating the 3/4 s/s from one | | | | make HHO" process. You'll now connect your |
| another--two flat pieces of plexiglass which you've | | | | grounds to each of your eight 1/4 s/s pipes. Slide |
| cut into a circle. These must fit inside your 6 or 8 | | | | these into the 3/4 pipes. Put them into those |
| inch PVC, with one close to the top and one close | | | | round plexiglass circles which you made earlier in |
| to the bottom. | | | | the process. Keep one near the bottom and one |
| HOW TO MAKE HHO: Next Steps | | | | near the top. Now slide this entire unit carefully |
| Our next steps in how to make HHO will have | | | | into the PVC. Finally, using two pieces of plexiglass |
| you using long wire ties (about four for each 3/4 | | | | a bit bigger than the PVC pipe, make a top and |
| s/s pipe), wrapping them through the inside of | | | | bottom. Note that you can drill all of your holes at |
| your 3/4 s/s pipe. Now slide your 1/4 inch s/s | | | | once if you temporarily laminate your plexiglass. |
| into the 3/4 pipe. Be certain that they don't touch | | | | You need eight holes for your wiring and four at |
| one another. About every 90 degrees, reposition | | | | the corners for the all-thread to hole your |
| the wire ties. | | | | complete unit together. You'll also need another |
| HOW TO MAKE HHO: Getting Closer Now | | | | hole in the center-top so you can put water into |
| Next in the process of how to make HHO, we'll | | | | the cell. The hole has to be threaded so that you |
| wire the s/s pipes. The 3/4 inch pipe will be | | | | can replace a bolt into it when it's in use. There |
| positive and the 1/4 will be negative. Important: | | | | should also be one other hole for running a tube |
| You must use all s/s wire, bolts, clamps, washers, | | | | to the manifold intake. CAUTION: IT'S ESSENTIAL |
| screws--everything must be s/s. Now wire your | | | | THAT ONLY AN ELECTRICIAN CONNECT THE |
| positive into the cell top and the negative through | | | | OIL PACK, AS THE DISCHARGES HAVE A |
| the cell's bottom. Be sure to ground each of your | | | | POTENTIALLY-LETHAL VOLTAGE. |
| 1/4 inch s/s pipes by themselves. Your 3/4 inch s | | | | |